![]() ![]() This does not mean you will have a failed or bad drive at the end of the relayout/rebuild process. However, you may disconnect it from your host computer, by ejecting (Mac) or Safely Removing Hardware (PC).ĭo not add or remove a drive from Drobo during this process. Note: During the data protection process, you will see a message indicating “Drobo cannot currently protect your data against hard drive failure.” This message tells you to take precautions:ĭo not turn off the power to your Drobo device during a relayout. Note: When the Drobo 5D is shut down, but still plugged in and connected to the computer via its Thunderbolt connector, the Drobo 5D will still be able to pass. During the data protection process, Drobo Dashboard will give you an estimated time for data protection to complete. Once the drive lights stay solid green, the data protection process is complete. You can move data to and from the Drobo storage device. You can continue to use your Drobo storage device to acces files or run programs. Although we recommend that you use Drobo Dashboard to shut down the Drobo device, you can also manually shut down the Drobo device safely using the. Your Drobo device is mounted and data accessible. In our initial setup, the Drobo 5D was loaded up with 5x 2TB drives and booted up after connecting over USB 3.0 to our DAS testbed. Previously, you would have to go to Tools Shutdown. If you’re all good, then shut it down and reinstall the drives in the original locations. Put the Drobo into standby: Drobo Dashboard > Advanced Controls > Tools > Standby. Wait for the Drobo to connect to the Drobo Dashboard. Reconnect Firewire, then power to the Drobo. As always, we recommend following best practices, which include backing up your data prior to installing the latest firmware. Disconnect Firewire, then power to the Drobo. Perform a pinhole reset (google the procedure) and then see if it shows up. To ensure optimal performance and to take advantage of the latest features, set your Drobo device to automatically check for software updates. ![]() Simply shut down your Drobos and eject your volumes in new locations. Pull all drives, taking note of the locations. If your Drobo device encounters bad blocks on the hard drives, etc., that will extend the time it takes for relayout as well. Organize your DroboApps and Firmware in the new Pending Updates section, appearing on the left-hand side within the Drobo Dashboard. The time depends upon the amount of data on the Drobo device, the size of the files, the speed of the host, etc. The rebuild or relayout process can indeed take a while, from a few minutes to several hours or even longer, depending on the amount of data. When you add or remove a drive, your Drobo storage device must begin a process of safely redistributing data across all available drives. When a drive goes bad, the data must be redistributed among the remaining drives. The Drobo device responds by going into relayout/rebuild to redistribute the data around these bad blocks. Problem: Drobo reports data protection is in progress with yellow blinking.Ī number of factors can cause your Drobo storage device to go into data protection mode:Īs time goes by, some drives may develop bad blocks.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |